Filter
Top Products
Replacing the hot-swap backplane
www.gateway.com
55
10 Holding the new backplane by the edges only, align it with the locking
tabs on the backplane bracket, then place it on the locking tabs (1).
11 Slide the backplane to the right, locking it into place on the backplane
bracket.
12 Insert the backplane bracket and backplane into the chassis (3) between
the two rows of button-shaped fixtures on the bottom of the chassis.
13 Reconnect all cables to the backplane.
14 Replace the system fans and fan duct by following the instructions in
“Replacing system fans” on page 46.
15 Follow the instructions in “Closing the server case” on page 32.
16 Reinstall the hot-swap drives back into the server. Make sure that you
install the drives into the same bays you removed them from in Step 4. For
instructions see “Removing and installing a hard drive” on page 37.
17 Replace the bezel by snapping it into place on the front of the server.