Filter
Top Products
Returning the autoloader for service
www.gateway.com
85
Packing the autoloader
Use the original packing material to pack the autoloader: the shipping
container, two foam insert packing pieces, the accessory kit box (or the filler
tube if your autoloader did not come with an accessory kit box), and the
antistatic bag. You will also need packing tape.
To pack the autoloader:
1 Place the antistatic bag over the autoloader.
2 Place a foam endcap on each side of the autoloader, then make sure that
the pieces fit snugly onto the autoloader.
Important
One end of the foam insert has a curved
piece. This end of the foam insert is
designed to fit the front of the
autoloader.
3 Place the autoloader down into the shipping box and push the back of
the autoloader towards the back end of the box.
4 Insert the empty accessory kit box (or filler tube) into the shipping box at
the front end of the autoloader in the space between the autoloader foam
inserts and the shipping container.
5 Place any necessary paperwork on top of the autoloader inside the box.
6 Close and seal the box.
7 Place the shipping label on the box.