Filter
Top Products
GCC Elite Color 16 Series User’s Guide
3-11
Solving Printer Power-on Problems
Solving Printer Power-on Problems
This section describes problems that can occur when starting up the printer. If the trouble per-
sists after performing the checks listed below, turn the printer off [
O
], disconnect the power
cord from the AC outlet, and see “ Appendix A General Information” to arrange for a technical
support or service or repair call.
CAUTION: To prevent the risk of fire or smoke generation, do not attempt to modify the
printer in any way.
WARNING: Before cleaning the printer or performing any other maintenance, be sure to turn
the printer off [
O
], and disconnect the power cord from the AC outlet to prevent the risk of
electric shock.
DESCRIPTION
POSSIBLE
CAUSE
REQUIRED
ACTION
No power. Power switch not turned
on. Switch is not set to
[
I
].
Check power switch. See
“Chapter 1 Unpacking and
Installing the Printer” for more
information
Power cord not properly
plugged into AC outlet or
AC connector on rear of
printer
Set power switch to [
O
] (off)
and plug in power cord firmly.
See “Chapter 1 Unpacking and
Installing the Printer” for more
information.
Voltage of AC power line
not correct.
Verify that AC outlet is rated for
the correct voltage and amperage
of your printer. See “Chapter 1
Unpacking and Installing the
Printer” for more information.
Power is frequently
interrupted
Printer is defective Turn printer off [
O
], disconnect
power cord from the AC outlet.
See “Appendix A General
Information” to arrange for a
technical support or service or
repair call.