Filter
Top Products
3-22 Section 3: Installation
February 3, 2000 70055MP Revision D
Modem Communications
To establish communications via a modem:
1. If not already installed, mount the modem inside the monitor using the
supplied Velcroattachments.
2. Connect the modem per the instructions supplied with it.
See Figure 3-11 for modem mounting location and typical connections.
3. Set JP12 on the I/O board to select the modem power supply. Refer to
Modem Power Supply Configuration earlier in this section.
4. Be sure the serial port speed rate is set to 19200 bps (positions 3 and 4
on SW4 on the CPU board should be open).
Figure 3-11: Modem Location and Connections