Filter
Top Products
Section 4: Operation 4-5
70055MP Revision D February 3, 2000
Current Time and Date Screen
The Current Time and Current Date screen (Figure 4-6) displays:
• The current time as read from the system clock and displayed in 24
hour format (HH/MM/SS).
• The current date as read from the system clock and displayed as:
Day MM/DD/YYYY.
NOTE: The system clock must be set to the correct date and time to
ensure that the LTC-MAP properly acquires data. If the date or time are
incorrect, refer to the SAGE documentation for procedures for setting
the date and time.
C u r r e n t T i m e :
1 2 : 3 0 : 2 2
C u r r e n t D a t e :
W
e d 0 9 / 1 7 / 1 9 9 7
Figure 4-6: Current Time and Date Screen
Acknowledging Alarms
Alarms are acknowledged by pressing the Acknowledge Alarm button,
located in the lower left corner of the face panel. Pressing Acknowledge
Alarm deactivates the alarm relay on the LTC-MAP so subsequent alarms
can trip the annunciator outputs.
NOTE: The LTC-MAP remains in alarm mode, and the
corresponding ALARM indicators remain lit, until the alarm
condition goes away.