Filter
Top Products
6. Rate Control: Ports 1-24 support ingress and egress rate control for each port. For example,
assume that Port 1 is set at 10Mbps. You can set its effective egress rate at 1Mbps and
ingress rate at 500Kbps. The device will perform flow control or backpressure to confine
the ingress rate to the specified rate.
Ingress: Type the effective ingress rate for a specific port. The valid range is 0 - 1000.
The units are 100K.
i. 0: disables rate control.
ii. 1 - 1000: valid rate value
Egress: Type the effective egress rate for a specific port. The valid range is 0 - 1000. The
units are 100K.
iii. 0: disable rate control.
iv. 1 - 1000: valid rate value.
7. Port Priority: This field is set at “Disable”, by default. You can set the priority of a
specific port to either “High” or “Low”.
8. Port Security: A port in security mode will be “locked” without permission of the address
learning. Only the incoming packets with SMAC already existing in the address table can be
forwarded normally. You can disable the port from learning any new MAC addresses, then
use the static MAC addresses screen to define a list of MAC addresses that can use the
secure port. Enter the settings, and then click the Apply button.
27