Filter
Top Products
Console - 1K Xmodem Firmware Update
s mode. So you must change the baud rate to 57600bps to download the firmware.
here are two situations in which to use the 1K X modem to update the firmware:
. You can enter "1K X modem receiver mode" by pressing any key within 5 seconds of the
system power being turned on.
. The system automatically enters "1K X modem receiver mode" if it detects the firmware
checksum failed while booting.
. Press the “Disconnect” button when you start 1K X modem modes.
Go to File -> Properties, change the baud rate to 57600bps, and then click OK.
We provide a 1k Xmodem to update the firmware via the console. The X modem only works in
57600bp
T
1
2
1
59