Filter
Top Products
3. Enabled:
You can enable or disable the ports.
“No” indicates that the port is disabled.
. Auto:
You can set the auto-negotiation mode to either “Auto”, “N-way Force” or “Force” for each
port.
. Spd/Dpx:
You can set the speed of ports 1-24 to either 100Mbps or 10Mbps. You can set the speed of
ports 25 & 26 at either 1000Mbps, 100Mbps or 10Mbps (depending on the module card
mode). You can set all of the ports at either full-duplex or half-duplex mode.
. Flow Control:
Full: You can enable the flow control (pause) function for full-duplex mode.
Half: You can enable the flow control (backpressure) function for half-duplex mode.
OTE:
ressing <Save> only can save one page configuration. If the static trunk groups exist, you can
ee them listed (ex: TRK1, TRK2…) after port 26, and you can configure all of the items as
bove.
“Yes” indicates that the port is enables.
4
5
6
N
P
s
a
66