Filter
Top Products
2. Group ID: You can configure up to seven trunk groups. Choose the "Group ID" and click
"Get".
3. LACP: If enabled, the group is an LACP static trunking group. If disabled, the group is a
local static trunking group. All ports support LACP dynamic trunking groups. If connecting
to a device that also supports LACP, the LACP dynamic trunking group will be created
automatically.
4. Work ports: Allows a maximum of four ports to be aggregated into each group. If the
group is LACP static trunking, the excess ports are standby and able to aggregate if work
ports fail. If the group is local static trunking, the number of ports must be the same as the
group member ports.
5. Select the desired ports for the trunking group. (Again, the maximum number of ports per
group is four.)
6. If LACP is enabled, you can configure LACP Active/Passive status for each port. This can
be done in the “State Activity” section.
7. Click Apply.
5.4.5.2 Aggregator Information
When you are configuring LACP aggregator, you can view the vital, corresponding information
in this section.
1. The page shown below is displayed when there are no active groups.
29