Filter
Top Products
Chapter 3 Entering Configuration Data 73
Chapter 3
Enabling/Disabling Fast Load
Enabling/Disabling Fast LoadEnabling/Disabling Fast Load
Enabling/Disabling Fast Load
These two terms are defined as follows:
Note Some host software does not support the fast load enabled
option.
Enable or disable the Fast Load feature from the Lib Config Menu. To set either
feature:
1. At the Lib Config Menu screen, press the arrow button until the cursor
underscores FAST LOAD.
2. Press the [SELECT] button.
An editing screen appears.
3. Press the up and down arrow buttons to select either ON or OFF.
4. Press the [SELECT] button to save the changes. (You may press the [MENU]
button to abort.)
5. If you have already changed the library’s SCSI ID and are planning to exit
the main Configuration Menu at this time, you must press the [RESET]
button. If you want to set other configuration values, continue with the next
section.
If you have not changed the library’s SCSI ID and are not setting other
configuration values, press the [MENU] button until you exit all menus.
Fast load on: The robot will mount a tape to a drive and then
immediately report the move completed.
Fast load off: The robot will mount a tape to a drive and wait at the
drive location until the tape is completely loaded before
reporting the move completed.