Filter
Top Products
HP OmniBook 2100/3000/3100 Removal and Replacement 2-7
4. When prompted, select “Create Hibernate Partition.”
OmniBook 2100/3100: We recommend that you create a 96-MB partition, the same as the factory
setup.
OmniBook 3000: We recommend that you create a 144-MB partition, the same as the factory
setup.
Removing a RAM Board
(User-Replaceable)
Table 2-5. RAM Board Replacement Part Numbers
Description Part Number Exchange OmniBook
Part Number 2100 3100 3000
RAM board, 16-MB SODIMM F1363-60001 F1363-69001
•••
RAM board, 32-MB SODIMM F1364-60001 F1364-69001
•••
RAM board, 64-MB SODIMM F1365-60001 F1365-69001
•••
Caution
Handle the RAM board only by its edges and provide proper grounding. Otherwise, you may
damage the board due to electrostatic discharge.
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the hard disk drive (see page 2-5).
3. Slide open the RAM cover about 3 mm, then lift off the cover.
Figure 2-5. Removing the RAM Cover
4. Release the two metal latches at the sides of the RAM board, so the free edge of the board pops
up.
5. Pull the board out of the connector.
RAM Cover