Filter
Top Products
HP OmniBook 2100/3000/3100 Removal and Replacement 2-21
• Floppy drive or other plug-in module (see page 2-4).
• Hard drive (see page 2-5).
• Display assembly (see page 2-9).
• Keyboard (see page 2-19).
3. Remove the heatsink by doing the following:
• Remove the three recessed screws from the heatsink.
Note: Do not remove the two middle screws from the heatsink. They hold a permanent part of
the assembly.
• Lift the front edge of the heatsink slightly and slide it toward the front of the computer until
the four tabs along the back edge are free from the case.
• Lift the right end of the heatsink and unplug the fan cable from the motherboard.
Figure 2-17. Removing the Heatsink
Screw, M2×5mm
Note: Smaller diameter
Heatsink
(includes fan/cable)
Fan cable
connector
Speaker/TouchPad
cable
CPU Thermal Kit (gasket and spacer)
Do not remove
these two screws.