Filter
Top Products
edge switch 2/16 service manual 2–77
Diagnostics
g. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓
The Fibre Channel link and switch appear operational.
29
Disconnect the fiber-optic jumper cable from the port and connect the cable to a spare
port.
Is a link incident reported at the new port?
YES NO
↓
Go to step 31.
30
The attached device is causing the recurrent link incident. Notify the customer of the
problem and have the system administrator:
a. Inspect and verify operation of the attached device.
b. Repair the attached device if a failure is indicated.
c. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓
The attached device, Fibre Channel link, and switch appear operational.
Contact the next level of support
31
The switch port reporting the problem is causing the recurrent link incident. The
recurring link incident indicates port degradation and a possible pending failure. Go to
step 11.
32
An implicit incident error (event code 581), loss of signal or loss of synchronization
(event code 583), not operational primitive sequence (NOS) received (event code
584), or SBAR module failure (event code 604) caused the switch to fault.
Perform the data collection procedure and return the Zip disk to Hewlett Packard for
analysis.