Filter
Top Products
Chapter 5 Problem Solving 312
Correcting Output Quality Problems
If the print server failed to link, verify that all cables are correctly connected.
If the print server still fails to link, follow the steps below to reconfigure the
print server.
1 Use the EIO menu to manually set the link speed (10 or 100 Mbps) and
communication mode (full or half-duplex) so that they match the network.
(See the EIO menu on page 460
.) For example, if the port on the network
switch is set for 100TX full-duplex operation, you must set the print server
for 100TX full-duplex operation.
2 Turn the printer off and back on.
3 Check the print server operation. If the print server fails to link, contact a
local authorized HP dealer or service representative.