Filter
Top Products
4. Select Ring Settings, and then select Distinctive Ring.
5. A message appears stating that this setting should not be changed unless you have multiple
numbers on the same telephone line. Select Yes to continue.
6. Do one of the following:
●
Select the ring pattern assigned by your telephone company to fax calls.
- Or -
●
Select Auto Detect, and then follow the instructions on the printer control panel.
NOTE: If the Ring Pattern Detection feature cannot detect the ring pattern or if you cancel the
feature before it finishes, the ring pattern is automatically set to the default, which is All Rings.
NOTE: If you are using a PBX phone system that has different ring patterns for internal and
external calls, you must call the fax number from an external number.
Set the dial type
Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is Tone. Do not
change the setting unless you know that your phone line cannot use tone dialing.
NOTE: The pulse-dialing option is not available in all countries/regions.
To set the dial type
1. From the Home screen on the printer display, press the Up and Down buttons to select Fax, and
then press OK.
2. Select Settings, and then select Advanced Settings.
3. Select Dial Type, select Tone Dialing or Pulse Dialing, and then press OK.
Set the redial options
If the printer was unable to send a fax because the receiving fax machine did not answer or was
busy, the printer attempts to redial based on the settings for the busy-redial and no-answer-redial
options. Use the following procedure to turn the options on or off.
●
When Busy: If this option is turned on, the printer redials automatically if it receives a busy
signal. The factory-set default for this option is Redial.
●
When No answer: If this option is turned on, the printer redials automatically if the receiving fax
machine does not answer. The factory-set default for this option is No Redial.
To set the redial options
1. From the Home screen on the printer display, press the Up and Down buttons to select Fax, and
then press OK.
2. Select Settings, and then select Auto Redial.
3. Select the appropriate option, and then press OK.
ENWW Change fax settings 51