Filter
Top Products
Table 7-1 Postinstallation and Postupgrade Checklist
SectionTask
Section 7.2 (page 127)For a newly installed system disk, you can back up the disk. (At this
point, you could reinstall OpenVMS onto the disk instead.)
For a newly upgraded system disk, if it is not going to be a shadow set
member, back up the system disk as a safeguard before proceeding
with the next steps. If your newly upgraded system disk is going to
be a shadow set member, you can re-form it in a later step. As an
optional precaution, you can back up the system disk as well.
□
Section 7.3 (page 128)Register any licenses that were not registered during the installation;
for an upgrade, register any new licenses.
□
Section 7.4 (page 129)New installations only (optional): Set system parameters to enable volume
shadowing.
□
Section 7.5 (page 130)Alpha upgrades only: Tune BAP system parameters.□
Section 7.6 (page 131)If you set system parameters to enable volume shadowing or removed
hardcoded BAP system parameters, run AUTOGEN and reboot.
□
Section 7.7 (page 131)If you want to form a shadow set for a system disk, you can do this
now or later. If you upgrade a disk in a volume shadowing
environment, re-form the shadow set.
□
New installations, some upgrades: Perform the following tasks that
generally apply to new installations only but could also apply after an
upgrade:
□
Section 7.8.1 (page 133)Create proxy files, if required.□
Section 7.8.2 (page 133)Set up the queue manager and start the default batch and print
queues.
□
Section 7.8.3 (page 134)Configure a multihead system, if applicable.□
Section 7.8.4 (page 135)Configure DECnet if it was installed. After an upgrade, perform
only if DECnet was added during the upgrade.
□
Section 7.8.5 (page 135)Configure TCP/IP Services for OpenVMS if it was installed. After
an upgrade, configure TCP/IP Services only if it was added during
the upgrade.
□
Section 7.8.6 (page 136)If you are using neither DECnet nor TCP/IP Services, install and
configure third-party networking software, if necessary.
Networking software is required to download patches and for
certain layered products.
□
Initialize or configure the following products, as needed:□
Section 7.9.1 (page 136)Initialize CDSA.□
Section 7.9.2 (page 137)Configure Availability Manager.□
Section 7.9.3 (page 138)Configure Kerberos.□
Section 7.9.4 (page 139)Configure SSL for OpenVMS.□
Section 7.9.5 (page 140)On Integrity servers using services that depend on WBEM Services
for OpenVMS, configure WBEM Services for OpenVMS.
□
Section 7.9.6 (page 144)On Integrity servers using services that depend on WBEM
Providers, configure WBEM Providers for OpenVMS.
□
Section 7.9.7 (page 146)On Integrity servers that use Instant Capacity (iCAP) or Temporary
Instant Capacity (TiCAP), configure the iCAP software.
□
Section 7.9.8 (page 147)On Integrity servers that use HP SIM services, configure HP SIM.□
126 After Installing or Upgrading the OpenVMS Operating System