Filter
Top Products
13. Now you can boot the OpenVMS Integrity servers image, either using the EFI boot menu
or the following command at the EFI Shell prompt:
Shell> fs0:\efi\boot\bootia64.efi
As shown in the following example, the OpenVMS displays several messages followed by
the operating system menu. You can now begin the installation or upgrade of OpenVMS
on the Integrity servers.
NOTE: The %SYSTEM-I-MOUNTVER messages and the Universal Serial Bus Configuration
Manager message are new to OpenVMS Version 8.4 and are seen only when using USB or
vMedia devices for booting the Integrity rx2660, rx3600, and rx6600 servers.
.
.
.
.
Installing required known files...
%RUN-S-PROC_ID, identification of created process is 00000024
%SYSTEM-I-MOUNTVER, DNA0: is offline. Mount verification in progress.
%SYSTEM-I-MOUNTVER, DNA0: has completed mount verification.
Universal Serial Bus Configuration Manager, Version V2.1 Reset Unconfigured devices
Configuring devices...
%PKA0, Copyright (c) 2001 LSI Logic, PKM V1.1.01 Chip LSISAS1068
%PKA0, LSISAS1068 firmware version is 1.16.0.0
%EWA0, Auto-negotiation mode assumed set by console
%EWA0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWA0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%EWB0, Auto-negotiation mode assumed set by console
%EWB0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWB0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%EWA0, Link up: 100 mbit, full duplex, flow control (txrx)
%EWB0, Link up: 100 mbit, full duplex, flow control (txrx)
****************************************************************
You can install or upgrade the OpenVMS I64 operating system
or you can install or upgrade layered products that are included
on the OpenVMS I64 distribution media (CD/DVD).
You can also execute DCL commands and procedures to perform
"standalone" tasks, such as backing up the system disk.
Please choose one of the following:
1) Upgrade, install or reconfigure OpenVMS I64 Version X8.4
2) Display layered products that this procedure can install
3) Install or upgrade layered products
4) Show installed products
5) Reconfigure installed products
6) Remove installed products
7) Find, Install or Undo patches; Show or Delete Recovery Data
8) Execute DCL commands and procedures
9) Shut down this system
Enter CHOICE or ? for help: (1/2/3/4/5/6/7/8/9/?)
Perform the installation or upgrade. Follow the installation instructions in “Installing OpenVMS
Using Option 1 of the Operating System Menu” (page 55), or the upgrade instructions in
“Performing the Upgrade” (page 107).
NOTE: After an installation finishes, you must register all licenses for use of the operating
system and any installed layered products. For information about registering licenses, see
Section 7.3 (page 128).
After the installation or upgrade finishes, you can change responses that you made to the
installation or upgrade script and perform any other postinstallation or postupgrade tasks. HP
recommends that you specify a new SYSTEM password rather than using the default.
D.2 Using vMedia Independently of HP SIM 287