Filter
Top Products
Include the first page of each fax on the fax confirmation, fax error, and last call
reports
1. On the control panel, press the Fax Menu
button.
2. Use the arrow buttons to select the Fax
Reports menu, and then press the OK
button.
3. Use the arrow buttons to select the Include
1st page menu, and then press the OK
button.
4. Use the arrow buttons to select the On option,
and then press the OK button to confirm the
selection.
Change error correction and fax speed
Set the fax-error-correction mode
Usually, the product monitors the signals on the telephone line while it is sending or receiving a fax. If
the product detects an error during the transmission and the error-correction setting is On, the
product can request that the portion of the fax be resent. The factory-set default for error correction is
On.
You should turn off error correction only if you are having trouble sending or receiving a fax, and you
are willing to accept the errors in the transmission. Turning off the setting might be useful when you
are trying to send a fax overseas or receive one from overseas, or if you are using a satellite
telephone connection.
1. On the control panel, press the Setup
button.
2. Use the arrow buttons to select the Service menu, and then press the OK button.
3. Use the arrow buttons to select the Fax Service menu, and then press the OK button.
4. Use the arrow buttons to select the Error Correction menu, and then press the OK button.
5. Use the arrow buttons to select the On or Off option, and then press the OK button to save the
selection.
Change the fax speed
The fax-speed setting is the modem protocol that the product uses to send faxes. It is the worldwide
standard for full-duplex modems that send and receive data across telephone lines at up to 33,600
bits per second (bps). The factory-set default for the fax-speed setting is Fast(V.34).
176 Chapter 2 Solve problems ENWW