Filter
Top Products
After performing service
● Plug in the power cable.
● Reinstall the print cartridge.
●
Load paper in the product.
Post-service test
Perform the following test to verify that the repair or replacement was successful.
Print-quality test
1. Verify that you have completed the necessary reassembly steps.
2. Make sure that the tray contains clean, unmarked paper.
3. Attach the power cord and interface cable or interface cables, and then turn on the product.
4. Verify that the expected startup sounds occur.
5. Print a configuration page, and then verify that the expected printing sounds occur.
6. Print a demo page, and then verify that the print quality is as expected.
7. Send a print job from the host computer, and then verify that the output meets expectations.
8. Clean the outside of the product with a damp cloth.
Parts removal order
NOTE: In the following list, parts shown with blue text should be removed only in a clean-room
environment. See the Service Manual Addendum for details about removing and replacing these
parts.
4 Chapter 1 Removal and replacement ENWW