Filter
Top Products
Control panel message Description Recommended action
REPLACE SUPPLIES
For status press
The supplies gauge will display the
consumption levels of print
cartridges.
Multiple supplies are at the end of their
useful life. If the supplies affected are
cartridges only, printing has stopped
because the COLOR SUPPLY OUT
setting in SYSTEM SETUP is set to
STOP. If the fuser or transfer kit is
affected, then printing always stops.
1. Press to access the SUPPLIES
STATUS menu.
2. Press
and to highlight the
specific supply that has a problem.
3.
Press
to view help for the supply.
4. Press
and to step through the
instructions.
5. Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded
Web server for more information.
REPLACE SUPPLIES
To continue press
The supplies gauge will display the
consumption levels of print
cartridges.
Multiple supplies are at the end of their
useful life and the SUPPLIES LOW
setting in SYSTEM SETUP is set to STOP.
1. Press to access the SUPPLIES
STATUS menu.
2. Press
and to highlight the
specific supply that has a problem.
3.
Press
to view help for the supply.
4. Press
and to step through the
instructions.
5. Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded
Web server for more information.
REPLACE SUPPLIES
Using black only
The supplies gauge will display the
consumption levels of print
cartridges.
alternates with
Ready
For help press
The supplies gauge will display the
consumption levels of print
cartridges.
At least one color cartridge is at the end
of its useful life and the COLOR
SUPPLY OUT setting in SYSTEM
SETUP is set to autoContinueBlack.
Printing will continue using black toner
only.
Press to identify which supplies should
be replaced. Replace identified supplies
to continue printing in color.
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. Printing
will not continue until the the transfer kit
has been replaced.
1. Open the top and front cover.
2. Remove the old unit by pressing the
blue buttons on either side of the unit.
3. Slide the old unit out of the printer.
4. Install a new transfer unit.
5. Close the front and top covers.
6. Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded
Web server for more information.
Control panel messages (continued)
ENWW Control panel messages 175