Filter
Top Products
10. Press to select MANUAL SETTINGS.
11. Press
to highlight MANUAL.
12. Press
to highlight IP ADDRESS.
13. Press
to select IP ADDRESS.
Note
The first of three sets of numbers is highlighted. If there is not a number highlighted, a
highlighted empty underscore appears.
14. Press
or to increase or decrease the number for configuring the IP address.
15. Press
to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct IP address is entered.
17. Press the M
ENU
button to return to the Ready state.
Setting the subnet mask
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to highlight MANUAL SETTINGS.
11. Press
to select MANUAL SETTINGS.
12. Press
to highlight SUBNET MASK.
13. Press
to select SUBNET MASK.
Note
The first of three sets of numbers is highlighted.
14. Press
or to increase or decrease the number for configuring the subnet mask.
15. Press
to move to the next set of numbers.
16. Repeat steps 14 and 15 until the correct subnet mask is entered.
17. Press the M
ENU
button to return to the Ready state.
Setting the syslog server
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
64 Chapter 3 I/O Configuration ENWW