Filter
Top Products
10. Press to highlight ENABLE.
11. Press
to select ENABLE.
12. Press
to highlight ON or OFF.
13. Press
to select ON or OFF.
14. Press the M
ENU
button to return to the Ready state.
Setting the idle timeout
1. Press to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to highlight MANUAL SETTINGS.
10. Press
to select MANUAL SETTINGS.
11. Press
to highlight IDLE TIMEOUT.
12. Press
to select IDLE TIMEOUT.
13. Press the
or arrow to to increase or decrease the number of seconds for the idle
timeout.
14. Press
to save the idle timeout.
15. Press the M
ENU
button to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight LINK SPEED.
9. Press
to select LINK SPEED.
ENWW Network configuration 67