Filter
Top Products
Control panel message Description Recommended action
REPLACE TRANSFER KIT
For help press
alternates with
REPLACE TRANSFER KIT
To continue press
The transfer unit is nearing the end of its
useful life and the SUPPLIES LOW
setting in SYSTEM SETUP is set to STOP.
1. Order the transfer kit.
2. To continue printing, press
.
3. To replace the transfer kit, perform
the following steps:
● Open the top and front cover.
● Remove the old unit by
pressing the blue buttons on
either side of the unit.
● Slide the old unit out of the
printer.
● Install a new transfer unit.
● Close the front and top covers.
● Supplies ordering information is
also available from the
embedded Web server. See
Using the embedded Web
server for more information.
Request accepted
please wait
The printer has accepted a request to
print an internal page, but the current job
must finish printing before the internal
page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not
completed successfully.
Attempt upgrade again.
Resetting Kit Count YES is selected in the Reset Supplies
menu, to reset the counts for any of the
supplies that cannot be detected as new.
No action necessary.
RESTORE FACTORY
SETTINGS
The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
Rotating <COLOR>
motor
To exit press
the STOP key
A component test is in progress; the
component selected is the <color>
Cartridge motor.
Press S
TOP
when ready to stop this test.
Rotating motor
To exit press
the STOP key
The printer is executing a Component
Test and the component selected is a
motor.
Press S
TOP
when ready to stop this test.
Setting saved A menu selection has been saved. No action necessary.
Control panel messages (continued)
176 Chapter 8 Problemsolving ENWW