Filter
Top Products
Replacing the Fuser Cartridge/BTR
Appendix B: Replacing Consumables ❖ B-7
8
Secure the fuser cartridge by replacing
the mounting screws that were removed
in Step 5 on page B-6.
If you do not need to re-install the Duplex
Module, close the rear cover and skip to
Step 11.
9
Insert the Duplex Module through the
guide channels.
10
Make sure the green side-locks at both
ends click into position. Then close the
rear cover.
11
Open the front cover and remove the
EP cartridge by lifting it towards the rear
of the printer then pulling it up and out.
kug-appb Page 7 Thursday, March 6, 1997 4:50 PM