Filter
Top Products
Duplex Module
Appendix C: Installing and Removing Printer Options ❖ C-23
Removing the
Duplex Module
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Open the rear cover.
3
Remove the Duplex Module by pushing
the green lock buttons on either side of it.
Be careful not to touch the metal
part of the motor at the right end
of the duplex module—it is hot
after continuous two-sided
printing.
Store the Duplex Module in its original
packaging.
4
Close the rear cover, plug in the power
cord, and power ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
kug-appc Page 23 Thursday, March 6, 1997 4:51 PM