Filter
Top Products
Replacing the Fuser Cartridge/BTR
Appendix B: Replacing Consumables ❖ B-9
16
Pull the tab to remove the BTR’s
protective covering.
17
Re-insert the EP cartridge into the guide
channels marked by the arrows inside the
top cover. Push in until it clicks in place,
then close the front cover.
18
Plug in the power cord. Press and hold
Online and Menu while powering
ON the printer. This will reset the Fuser
Life counter and release the warning
message.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If the Replace Fuser Cartridge
message still appears, Step 18.
If any other message is displayed, see
Table 6.2 starting on page 6-6.
kug-appb Page 9 Thursday, March 6, 1997 4:50 PM