Filter
Top Products
PostScript SIMM
C-14 ❖ LN17 and LN17ps Printers User Guide
4
Carefully pull out on the locking clips to
release the PostScript SIMM.
5
Rotate the PostScript SIMM up to a
vertical position, then lift it out.
6
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
7
Replace the power and interface cables
and power ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
8
Press Online , then Reset and you
see:
Reset Menu
Reset Printer
9
Press Down and you see:
Reset Menu
Reset Menus
kug-appc Page 14 Thursday, March 6, 1997 4:51 PM