Filter
Top Products
PostScript SIMM
Appendix C: Installing and Removing Printer Options ❖ C-13
Removing the
PostScript SIMM
Caution
SIMMs and controller boards are sensitive to static electricity.
Before removing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the removal,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Loosen the thumb screws and pull out the
controller board.
3
Place the controller board on a ream of
paper.
kug-appc Page 13 Thursday, March 6, 1997 4:51 PM