Filter
Top Products
Control Panel Options
Appendix D: Control Panel Options ❖ D-13
Pitch
PCL Emulat Menu
0.44 - 99.99 by.01 steps
10.00* c.p.i.
Specifies the number of characters per inch (cpi) for the font represented by
Font Number (page D-7).
It appears only when the Font Number setting (page D-7) specifies a scalable
fixed pitch font.
Up increments pitch by .01 cpi, from .44 to 99.99 cpi.
Down decrements by .01 cpi.
Hold Up o r Down for approximately two seconds and Pitch scrolls in
increments of 1.
Point Size
PCL Emulat Menu
4.00 - 999.75 by.25 steps
12.00* points
Specifies the point size (a measurement for type height, 1 point equals 0.351 mm
or approximately 1/72 inch) for the font represented by Font Number (page D-7).
Appears only when the Font Number setting specifies a scalable proportional
spaced font, such as Times New Roman.
Up increments point size by .25 points, from 4.0 to 999.75 points.
Down decrements by .25 points.
Hold Up o r Down for approximately 2 seconds and Pitch scrolls in
increments of .25 points.
Port Enable
Parallel Menu
LocalTalk Menu
Ethernet Menu
Off
On*
Controls activation of the port.
• When set to On, the port is enabled so that the printer can receive print jobs
through it. The port becomes part of a port polling sequence that includes all
ports.
• When set to Off, the port is disabled so that no communication with the host
occurs through this port. If you are not using the parallel port, you can set
Port Enable to Off.
Port Timeout
Parallel Menu
LocalTalk Menu
Ethernet Menu
5-999 seconds
30* seconds
Time interval for determining when to end an incomplete print job and poll the
next port in the polling sequence.
This option works in conjunction with Auto Job End (page D-3).
Table D.1 Control Panel menu options, settings, and descriptions (continued)
Menu Option,
Location(s),
Setting(s)
Description
Table D.1 Page 11 of 16