Filter
Top Products
Hitachi Command Control Interface (CCI) User and Reference Guide 131
3.3.2 Software Installation for Windows
Systems
Make sure to install CCI on all servers involved in CCI operations. If network (TCP/IP) is not
established, install a network of Windows attachment, and add TCP/IP protocol.
To install the CCI software on a Windows system:
1. If a previous version of CCI is already installed, uninstall it as follows:
a) Confirm that HORCM is not running. If it is running, shut it down:
One CCI instance: D:\HORCM\etc> horcmshutdown
Two CCI instances: D:\HORCM\etc> horcmshutdown 0 1
b) If Hitachi TrueCopy/ShadowImage commands are running in the interactive mode,
terminate the interactive mode and exit these commands using -q option.
c) Remove the previous version of CCI using the Add/Remove Programs control panel.
2. Insert the installation medium (e.g., CD-ROM) into the proper I/O device.
3. Run Setup.exe, and follow the instructions on screen to complete the installation.
4. Verify installation of the proper version using the raidqry command:
D:\HORCM\etc> raidqry -h
Model: RAID-Manager/Windows2000
Ver&Rev: 01-22-03/02
Usage: raidqry [options]
3.3.3 Software Installation for OpenVMS
®
Systems
Make sure to install CCI on all servers involved in CCI operations. Establish the network
(TCP/IP), if not already established. CCI will be provided as the following PolyCenter
Software Installation (PCSI) file:
HITACHI-ARMVMS-RM-V0122-2-1.PCSI
HITACHI-I64VMS-RM-V0122-2-1.PCSI
Follow the requirements and restrictions in section 3.5 for porting for OpenVMS.
CCI also r
equires that POSIX_ROOT is existing on the system, so you must define the
POSIX_ROOT before installing the CCI software. It is recommended that you define the
following three logical names for CCI in LOGIN.COM:
$ DEFINE/TRANSLATION=(CONCEALED,TERMINAL) SYS$POSIX_ROOT “Device:[directory]”
$ DEFINE DCL$PATH SYS$POSIX_ROOT:[horcm.usr.bin],SYS$POSIX_ROOT:[horcm.etc]
$ DEFINE/TABLE=LNM$PROCESS_DIRECTORY LNM$TEMPORARY_MAILBOX LNM$GROUP
$ DEFINE DECC$ARGV_PARSE_STYLE ENABLE
$ SET PROCESS/PARSE_STYLE=EXTENDED
where Device:[directory] is defined as SYS$POSIX_ROOT