Filter
Top Products
4 - 10
LED Illumination
Note: This parameter only applies for decoding if Decoding Illumination is enabled. If Decoding Illumination is disabled, all
illumination is off for that mode, regardless of this LED Illumination setting.
Note: Default: PL4407: Internal Illumination MS4407: External Illumination
The imager has three small bright LEDs situated above the scan aperture. Internal LED illumination turns the LEDs on
during scan mode. The effectiveness of the illumination decreases as the distance to the target increases.
External illumination setting turns the LEDs off during scan mode.
Internal and External Illumination turns the LEDs on during scan mode.
See Decoding Illumination (page 4-8).
Select an illumination setting by scanning one of the bar codes shown below.
Internal Illumination
External Illumination
Internal and External Illumination