Filter
Top Products
1 - 1
1
Ring Scanner Agency Compliance
Ring bar code decoders meet or exceed the requirements of all applicable standards organizations for safe operation. However,
as with any electrical equipment, the best way to ensure safe operation is to operate them according to the agency guidelines
that follow. Read these guidelines carefully before using your Ring Scanner.
This documentation is relevant for the following models: 8600 series (861x, 862x) Ring Scanners.
Label Locations
Laser Label
If the following label is attached to your ring bar code decoder, it indicates the ring bar code decoder contains an engine with a
laser aimer:
Laser Safety Statement
This device has been tested in accordance with and complies with IEC60825-1:2007 and EN60825-1:2007). Complies with 21
CFR 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
LASER LIGHT, DO NOT STARE INTO BEAM, CLASS 2 LASER PRODUCT, 1.0 mW MAX OUTPUT: 630-680nM.
Laser Warnings
• Do not look into the laser’s lens.
• Do not stare directly into the laser beam.
• Do not remove the laser caution labels from the Ring Scanner ring bar code decoders.
• Do not connect the laser bar code aperture to any other device. The laser bar code aperture is certified for use with either the
HX2/HX3 or the Dolphin 70e Black in the Honeywell Wearable Solution only.
Left Side of Scanner head Right Side of Scanner Head
Caution:
Laser radiation when open. Read the caution labels. Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
Laser Safety Label
Part Number and Serial Number Label
Compliance Label
!