Filter
Top Products
4 - 1
4
2D Laser Imager Programming Bar Codes
Introduction
These bar codes, explanations and instructions are for programming the SE4400 laser imager engine in your ring imager. Do
not scan the bar codes in this section with any other imager or laser engine.
Note: A ring imager does not have beep / audio capability.
Assumption: The user is familiar with Windows on-screen functions.
Scan engine manufacturers may offer more bar codes and options than are contained in this chapter. Note that the bar codes in
this chapter are only those supported by Honeywell and the mobile devices it manufactures or supports. ContactCustomer
Support (page 7-1) if you need help when using the bar codes in this chapter.
To change a parameter value scan the appropriate bar code in this chapter. The new value replaces the standard default value
in memory.
An asterisk (*) next to an option indicates the default setting.
Using the imager like a camera (or for OCR decoding) is not supported in this release.
The following SE4400 bar code symbologies are supported:
Note: The default value for all Postal Code symbologies is “Enabled.” For best performance when reading a specific postal
symbology, all other postal symbologies should be disabled.
Note: Prefix / Suffix
Ring decoder engine prefix and suffix parameters should not be set, changed, or reset using the Prefix and Suffix bar codes
shown in this section. When the Ring Scanner Module is reset to defaults, the prefix and suffix settings revert to their default
values and need to be scanned again. Use the ScanWedge NGW Power Tool (Dolphin 70e) or Scanner control panel (HX2 or
HX3) in the host computer to store prefix and suffix values.
Refer to the host User’s Guide for information and instruction on setting up the following ring imager parameters:
• Enable/Disable decoding sounds
• Imager LED Illumination
• COM1 Serial Parameters
• Code ID: AIM, Symbol, Custom
• Symbology Settings including Prefix/Suffix
• Control Character Mapping
• Custom Identifiers
• Pre-Configured Defaults
Symbology
Codabar Aztec / Aztec Inverse
Code 11 PDF417
Code 128 MicroPDF
Code 39 Code 128 Emulation
Code 93 Data Matrix / Data Matrix
Inverse
Composites Maxicode
Discrete 2 of 5 MicroQR
Interleaved 2 of 5 QR Code / QR Inverse
MSI Plessey GS1 DataBar (RSS)
UPC / EAN Postal Codes