Filter
Top Products
4 - 57
NOTIS Editing
When enabled, the start and stop characters are stripped from a decoded Codabar symbol.
Set this parameter by scanning either of the bar codes shown below.
Set Lengths for Codabar
L1 Default: 5
L2 Default: 55
Lengths for Codabar may be set for:
any length,
one or two discrete lengths,
or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start
or stop characters.
See the table titled ASCII Character Equivalents (page 6-1).
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Cod-
abar symbols containing 14 characters, scan the Codabar One Discrete Length bar code and then “1” and “4” bar
codes using the Imager Keypad Number Symbols (page 4-81).
To begin setting one discrete length, scan this Codabar One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Enable NOTIS Editing
* Disable NOTIS Editing