Filter
Top Products
STL2 Server Board TPS Basic Input Output System (BIOS)
Revision 1.0 4-49
•
The 8-bit test point is broken down to four 2-bit groups.
•
Each group is made one-based (1 through 4)
•
One to four beeps are generated based on each group’s 2-bit pattern.
Example:
Checkpoint 04Bh will be broken down to: 01 00 10 11
And the beep code will be: 2 – 1 – 3 – 4
Table 4-24. Standard BIOS Port-80 Codes
CP Beeps Reason
02 Verify Real Mode
04 Get Processor type
06 Initialize system hardware
08 Initialize chipset registers with initial POST values
09 Set in POST flag
0A Initialize Processor registers
0B Enable Processor cache
0C Initialize caches to initial POST values
0E Initialize I/O
0F Initialize the local bus IDE
10 Initialize Power Management
11 Load alternate registers with initial POST values
12 Restore Processor control word during warm boot
14 Initialize keyboard controller
16 1-2-2-3 BIOS ROM checksum
18 8254 timer initialization
1A 8237 DMA controller initialization
1C Reset Programmable Interrupt Controller
20 1-3-1-1 Test DRAM refresh
22 1-3-1-3 Test 8742 Keyboard Controller
24 Set ES segment register to 4GB
28 1-3-3-1 Autosize DRAM, system BIOS stops execution here if the BIOS does not detect any usable
memory DIMMs
2A Clear 8 MB base RAM
2C 1-3-4-1 Base RAM failure, BIOS stops execution here if entire memory is bad
32 Test Processor bus-clock frequency
34 Test CMOS
35 RAM Initialize alternate chipset registers
36 Warm start shut down
37 Reinitialize the chipset
38 Shadow system BIOS ROM
39 Reinitialize the cache
3A Autosize cache