Filter
Top Products
STL2 Server Board TPS Jumpers and Connectors
Revision 1.0 5-67
Table 5-4. Jumper Block 1L4 Settings
Jumper Pin
Numbers
Function Jumper Position Function
1 – 2 FRB
Open, Enabled
Enables FRB
Closed, Disabled Disables FRB
3 – 4 Front Cover Chassis Intrusion
Sensor
Open, Enabled
Enables Chassis Intrusion
sensing. This jumper may be
under as a chassis intrusion
switch connector.
5 – 6 Side Cover Chassis Intrusion
Sensor
Closed, Disabled
Disables Chassis Intrusion
sensing
Open, Enabled Enables Chassis Intrusion
sensing
7 – 8 No Function
Open, Not Used
No Function
9 – 10 Reserved
Open, Not Used
No Function
11 – 12 No Function
Open, Not Used
No Function
9 – 11 Spare
Closed, Spare
Provides a spare jumper
5.1.3 Setting Configuration Jumper Block 6A
Setting the jumpers on system board jumper block 6A enables the user to configure the front
cover chassis intrusion sensing. Jumper 6A pins 1-2 may also be used as a chassis intrusion
switch connector. The following table lists the factory default settings for jumper block 6A.
Table 5-5. Jumper Block 6A Settings
Jumper Pin
Numbers
Function Jumper Position Function
1 – 2 Front Cover Chassis
Intrusion Sensor
Open, Enabled
Enables Chassis Intrusion sensing. This
jumper may be under as a chassis intrusion
switch connector.
Closed, Disabled Disables Chassis Intrusion sensing
3 – 4 Reserved
Open, Enabled
Enables Chassis Intrusion sensing
5 – 6 No Function
Closed, Disabled
Disables Chassis Intrusion sensing
7 – 8 Reserved
Open, Not Used
No Function
5.2 Connectors
This section provides pin information about the connectors on the STL2 server board.