Juniper Networks M120 Network Router User Manual


 
Integrated support for G.703 unframed mode and G.704 framed mode with CRC; this
feature is user-configurable
NOTE: The G.704 implementation supports speeds slower than 2.048 Mbps; multiple channels
within a single E1 interface are not supported.
Configurable clock source: Internal or loop
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Point-to-Point Protocol (PPP)
Software features
Two versions:
Four RJ-48 connectors (one per port)
Four coaxial connectors
Custom 10-ft (3.05-m) posilock to BNC male cable, separate Rx and Tx
Cables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
Alarm indication signal (AIS)
Bipolar violations
Excessive zeros
Far-end block errors (FEBE, E-bit errors)
Loss of frame (LOF), Loss of signal (LOS)
Local and remote loopback diagnostics
Yellow alarm bit (X-bit) disagreements
Alarms, errors, and
events
E1 PICs 51
E1 PICs