Juniper Networks M120 Network Router User Manual


 
MultiServices 100: JUNOS 8.2R2 and later (Type 1)
NOTE: This PIC requires the 710-017980 version of the FPC1.
MultiServices 400: JUNOS 8.2 and later (Type 2)
MultiServices 500: JUNOS 8.3 and later (Type 3)
Supports tunnel services. This feature is included with the PIC and does not require an
individual license.
Individual licenses must be purchased for additional services.
Power requirement:
Type 1: 0.52 A @ 48 V (25 W)
Type 2: 0.69 A @ 48 V (33 W)
Type 3: 0.83 A @ 48 V (40 W)
Description
Active monitoring on:
Type 1: up to 1.6 million flows
Type 2: up to 3.2 million flows
Type 3: up to 3.2 million flows
Hardware features
Support for up to 2000 service sets
Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces
Depending on your JUNOS release and individual licenses, software features for this PIC can
include the features listed in Table 24 on page 81. For more information about the software
features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.
Software features
Status LED, one tricolor:
OffPIC is offline and it is safe to remove it from the chassis.
GreenPIC is operating normally.
AmberPIC is initializing.
RedPIC has an error or failure and no further harm can be done by removing it from
the chassis.
Application LED, one bicolor:
OffService is not running.
GreenService is running under acceptable load.
AmberService is overloaded.
LEDs
Table 24: MultiServices PICs Software Features Supported on the M120 Router
MultiServices 500MultiServices 400MultiServices 100Software Feature
GRE Key
GRE dont-fragment
MultiServices PICs 81
MultiServices PICs