Juniper Networks M120 Network Router User Manual


 
Supports four queues per port
Random early detection (RED)
Transmitter Signal Element Timing is looped from the timing received on the Transmitted
Signal Element DCE. EIA-530 ports support the ability to invert the Transmit Data Element.
The EIA-530 ports support the following rates:
2.048 Mbps
2.341 Mbps
2.731 Mbps
3.277 Mbps
4.09 Mbps
5.461 Mbps
8.192 Mbps
16.384 Mbps
V.35 ports support up to 2.048 Mbps
X.21 ports support up to 10 Mbps
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
Two DB-25 male connectors (one per port, included with PIC)
V.35 requires an EIA-530 to V.35 cable and connects to a V.35 DTE 34-pin Winchester
type male cable (one per port)
X.21 requires an EIA-530 to X.21 cable and connects to a X.21 DTE DB-15 male cable
Cables and connectors
Three bicolor per port:
Data set ready (DSR):
GreenDSR is detected or ignored
RedDSR expected but not present
Data carrier detect (DCD):
GreenDCD is detected or ignored
RedDCD expected but not present
Resynchronization:
GreenKeepalives are being received
RedData terminal ready (DTR) toggled from low to high (resynchronization pulses
are being sent)
LEDs
Per-port packet and byte counters
Resynchronization counters:
Number of resynchronizations initiated
Time of last resynchronization
Instrumentation
(counters)
EIA-530 PIC 55
EIA-530 PIC