Juniper Networks M120 Network Router User Manual


 
Optical diagnostics and related alarms
Per-port SONET/SDH framing
Link aggregation
Alarm and event counting and detection
Dual-router automatic protection switching (APS)
Multiprotocol Label Switching (MPLS) fast reroute
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
You can install any transceiver supported by the PIC. For information about installing and
removing transceivers, see the PIC and Transceiver Installation Instructions.
Duplex LC/PC connector (Rx and Tx)
Optical interface supportSee Table 29 on page 96, Table 30 on page 97, and
Table 31 on page 97
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the request chassis pic offline command in the
JUNOS System Basics and Services Command Reference.
Cables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
SONET/SDH OC12/STM4 (Multi-Rate) PICs with SFP 95
SONET/SDH OC12/STM4 (Multi-Rate) PICs with SFP