Juniper Networks M120 Network Router User Manual


 
Intelligent handling of oversubscribed traffic for Type 1 and Type 2 PICs
Optical diagnostics and related alarms
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
Virtual Router Redundancy Protocol (VRRP) support
Hierarchical shaping
Fine-grained queuing and shaping per logical interface at both ingress and egress
802.1q virtual LANs (VLANs)
VLAN stacking and rewriting
Channels defined by two stacked VLAN tags
Point-to-Point Protocol over Ethernet (PPPoE) over VLAN (JUNOS Release 8.5 and later.)
Multiple tag protocol identifiers (TPID) support
IP service for nonstandard TPID and stacked VLAN tags
802.1p rewrite per channel
Flexible mapping of channels and scheduler resources at both ingress and egress
Flexible Ethernet encapsulation
MAC learning, policing, accounting, and filtering
Software features
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
NOTE: Do not install SONET/SDH SFPs in the Gigabit Ethernet port. The port will not recognize
the SFP.
Fiber-optic small form-factor pluggable transceivers (SFPs):
Duplex LC/PC connector (Rx and Tx)
Optical interface supportSee Table 17 on page 69
Copper 1000Base-T SFPs:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
Pinout: MDI crossover
Length: 328 ft/100 m
Cables and connectors
OK or Status LED, one tricolor:
OffPIC is offline and it is safe to remove it from the router.
GreenPIC is operating normally.
AmberPIC is initializing.
RedPIC has an error or failure.
APP LED, one bicolor:
OffMonitoring application is not running.
GreenMonitoring application is running under acceptable load.
Port LEDs, one per port:
OffPort is not enabled.
GreenPort is online with no alarms or failures.
LEDs
68 Gigabit Ethernet IQ2 PICs with SFP
M120 Internet Router PIC Guide