Filter
Top Products
Installing the Hardware
2-6 Part No. 1H9613 June 1997
The enlarged view in the illustration shows the jumper labeling as
viewed from behind the printer looking toward the front.
LINK Jumper Selection (Non-10BaseT)
NOTE: Complete these steps only if link test integrity needs to
be enabled and your cabling is non-10BaseT.
If you have non-10BaseT twisted pair cabling, such as AT&T or
HP STARLAN, you may need to enable the link test integrity
function from the 10BaseT transceiver by changing the LINK
jumper on the Network Interface Card.
1. Find the small black jumper labeled “LINK” near the right front
side of the Network Interface Card.
This is the LINK jumper. When the Network Interface Card is
shipped, this jumper is positioned on only one of the two pins.
This specifies that the link test integrity is disabled.
2. Lift the black jumper up and off the pin and then push it back
down over both pins.