Filter
Top Products
Installing the Hardware
Part No. 1H9613 June 1997 2-9
Finishing up
Finish up the installation by closing the printer:
1. Grasp the black handles on the back of the printer and slide
the back of the printer in.
2. Using the Phillips-head screwdriver, replace the five screws
you removed.
3. Attach the Ethernet cable to the appropriate connector on the
Network Interface Card.
4. Plug in the printer, and turn it on. Make sure the power light
illuminates on the display panel.
5. When the printer completes initialization and the front display/
control panel displays the message “READY,” check the LEDs
for the Network Interface Card for the following indications.
The LEDs are located on the back of the printer.
• The yellow LED should be on and stable indicating correct
10BaseT connectivity between the printer and the Network
Interface Card and the network hub switch.
NOTE: Check the condition of the yellow light only if you are
using 10BaseT. It has no validity for ThinNet
connections.
If the yellow light does not illuminate or is unstable, check
for proper 10BaseT connectivity.