Filter
Top Products
Network Printer Parameters
Part No. 1H9613 June 1997 4-9
AppleTalk Phase
Default AppleTalk names are the equivalent of specific printer
product names:
Default: Phase 2
Optional: Phase 1
Changing the Phase
NOTE: If you are setting up a
Kodak Digital Science
TM
Desktop
Color Proofer 9000, refer to the User’s Guide for the
Network Interface Card shipped with the proofer for
specific instructions on using the operator control panel.
The default phase setting is EtherTalk Phase 2. To change the
phase, do the following steps:
1. Press Setup/Select on the display panel when “READY”
appears in the panel.
2. Press until “SETUP:PORTS” appears.
3. Press
Setup/Select
to access the “SETUP:PORTS”
submenu.
4. Press until “PORTS:ETHERTALK” appears.
5. Press
Setup/Select
to access the “PORTS:ETHERTALK”
submenu.
Power
Error
Cancel
Print
Setup/Selectscroll
”“
”“