Filter
Top Products
1.6. Memory Card
1-21
1.6. Memory Card
A memory card is a microchip card containing, for example, nonresident fonts and/or macros,
forms, etc. The printer reads the contents of the card into its internal memory when power is
switched on. The presence of this data in the printer memory can be confirmed on the status print-
out.
☛ The maximum card capacity that can be used is 32 Megabytes. The type of the
memory card to be used must be of either flash memory card (+5V type) or SRAM-
type and conform to the PCMCIA 2.1 (JEIDA 4.2) standards. Please use memory
cards recommended by Kyocera.
The memory card slot is located at the bottom right of the printer.
To insert and use a memory card:
1. Switch printer power off.
☛ Do not insert or remove a memory card while power is on. If the memory card is
removed while the printer is on, damage could result in the printer's electronics
or the memory card.
2. Insert the memory card in the slot. Insert it face
up, connector end first. Push it in all the way.
3. Switch printer power on. The printer reads the contents of the memory card during its power-
up sequence. The information (nonresident fonts, etc.) on the memory card is now available
for use.
If the memory card information is deleted from the printer's memory during the printing process,
it can be reread by using the mode selection function explained on the last page in this manual.
To remove the memory card:
1. Switch the power off.
2. Remove the memory card from the slot.
Memory Card Slot
[PC CARD (MEMORY)]
Memory Card