Kyocera FS-1700 Printer User Manual


 
Introduction
vii
IMPORTANT SAFEGUARDS
1.
Read all of these instructions and save these instructions for later use.
2.
Unplug this product from the wall outlet before cleaning.
3.
Do not use this product near water.
4.
Do not place this product on an unstable cart, stand, or table. The product may fall, causing
serious damage to the product.
5.
Slots and openings in the cabinet and the back are provided for ventilation to ensure reliable
operation of the product and to protect it from overheating, these openings must not be
blocked or covered. The openings should never be blocked by placing the product on a bed,
sofa, rug, or other similar surface. This product should never be placed near or over a radiator
or heat register. This product should not be placed in a built-in installation unless proper ven-
tilation is provided.
6.
This product is equipped with a 3-wire grounding type plug, a plug having a third (ground-
ing) pin. This plug will only fit into a grounding-type power outlet. This is a safety feature. If
you are unable to insert the plug into the outlet, contact your electrician to replace your
obsolete outlet. Do not defeat the purpose of the grounding-type plug.
7.
Do not allow anything to rest on the power cord. Do not locate this product where persons
will walk on the cord.
8.
If an extension cord is used with this product, make sure that the total of the ampere ratings
on the products plugged into the extension cord do not exceed the extension cord ampere
rating.
9.
Never push objects of any kind into this product through cabinet slots as they may touch
dangerous voltage points or short out parts that could result in a risk of fire or electric shock.
Never spill liquid of any kind on the product.
10.
Except as explained elsewhere in User's Manual, do not attempt to service this product your-
self. Removing covers may expose you to dangerous voltage points or other risks. Refer all
servicing in those compartments to service personnel.
11.
Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
A—When the power cord or plug is damaged or frayed.
B—If liquid has been spilled into the product.
C—If the product has been exposed to rain or water.
D—If the product does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions since improper
adjustment of other controls may result in damage and will often require extensive work by
a qualified technician to restore the product to normal operation.
E—If the product has been dropped or the cabinet has been damaged.