Filter
Top Products
4.2. Cleaning
4-7
Cleaning the Grid
1. Take the grid cleaner from protective bag in the
new toner kit, and remove the cap.
☛ The grid cleaner pad is impregnated with
water. Perform the following cleaning
procedure before the pad dries.
2. Attach the grid cleaner to the printer with the
pad uppermost, as shown in the diagram.
3. After attaching the grid cleaner, repeat the
action of slowly pulling out and then pushing
back in the main charger unit at least 5 times.
It is easier to pull out the main charger for the
first time if it is raised slightly, as shown in the
figure.
The grid part underneath the main charger is
cleaned by this procedure.
4. When the grid is clean, remove the grid
cleaner from the printer and dispose of it.
The grid cleaner is not re-usable.
5. After cleaning the charger wire, push the
cleaning knob all the way in and close the
side cover.
Protective Bag
Cap
Grid Cleaner
Grid Cleaner
Main Charger Unit
(1)
(2)
(3)