Filter
Top Products
5.5 Indicators and Messages
5-8
Maintenance Messages
Table 5.2 Maintenance Messages
Message Corrective Action
5
Open the top cover, then close tightly.
5
Open the side cover, then close tightly.
Open the paper feed unit, then close tightly.
8
The face-down tray has become full (approx. 250 pages). You must remove all
printed pages from the face-down tray. When the printer senses that the face-
down tray is empty again, it will continues printing into the face-down tray
(Model FS-3700+ only).
Add paper to the paper cassette or multi-purpose tray.
.,.+$
Add a sheet of paper to the multi-purpose tray (manual mode), and press the
CONTINUE key.
( 4)
The paper size does not match. The size of the paper in the cassette is different
to the size specified by the application software or by PRESCRIBE IIe. Either put
paper of the specified size into the cassette. See Section
1.4
.
If the CONTINUE key is pressed, printing will be resumed. However, if more than
one sheet is to be printed, the same message will again be displayed from the sec-
ond sheet onward.
You can abandon printing by pressing the CANCEL key.
9 Open the top cover or the paper feed unit and correct the paper jam (or paper
mis-feeding in the cassette). See Section
5.6
.
The printer's internal memory is running low due to the number of fonts and mac-
ros downloaded. Print a status page to see how much user memory is left, and
try deleting unnecessary fonts and macros. See the PRESCRIBE IIe DELF and DELM
commands explanation in the programming manual (CD-ROM).
:8;<
Replace the toner container using a new toner kit. See Section
4.1
.
Replace the toner container using a new toner kit. The printer does not operate
when this message is displayed. See section
4.1
.
.,.+$
Please clean the inside of the printer. See Section
4.2
.
This message will be displayed when replacing the toner container after the mes-
sage has been displayed. After
cleaning the inside of the printer, press the CONTINUE key and the printer will be
ready for printing.
8
"
Replace the old waste toner bottle with the new one which is included in the
TK-20/TK-20H toner kit. The message will also be shown if the waste toner bottle
has become full. The waste toner bottle should be replaced when the message
display eventually shows :8;< . See
Section
4.1
.
* 8
"
Install the waste toner bottle. See Section
1.4
. The printer does not operate when
this message is displayed.