Filter
Top Products
7. Slide the new card reader with retainer into the card reader drive bay until it snaps into position.
Figure26. Installing the card reader
8. Connect the card reader cable to the front USB connector 2 on the system board. See “Locating
parts on the system board” on page 13.
9. Locate the protective cover for the card reader drive bay on the front bezel. Remove the protective
cover by pressing the small tabs 1 to the left, and then pulling the tabs to completely disengage
the cover from the front bezel.
Figure27. Removing the card reader cover
10. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 41.
Chapter 5. Installing or replacing hardware 51