Filter
Top Products
7. Remove the card reader retainer from the old card reader and install it on the side of the new card reader.
Figure29. Installing the card reader retainer
8. Slide the new card reader with retainer into the drive bay until it snaps into position.
Figure30. Installing the card reader
9. Reconnect the card reader cable to the front USB connector 2 on the system board. See “Locating
parts on the system board” on page 13.
10. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 41.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 99.
Installing or replacing the front USB assembly
This section provides instructions on how to install or replace the front USB assembly.
Note: The front USB assembly is only available in some models.
Chapter 5. Installing or replacing hardware 53